sPOD Wiring Harness Adapter for ARB Compressor and Air Lockers
⚠ Call for Availability
This item may be on backorder. Please contact us to confirm supplier availability and estimated lead time before ordering.
Regular price
$18.00
Verified Fitment & Application Support
This product is selected for proper fitment and compatibility with the listed engine application. Our team is available to assist with fitment questions, installation considerations, and supporting components to ensure a smooth install and reliable performance.
Got Questions? Feel free to email us or call us at (503) 235-1947
Compliance & Restrictions
California Proposition 65 (Prop 65)
WARNING: This product can expose you to chemicals which is known to the State of California to cause cancer and/or reproductive harm.
For more information, visit www.P65Warnings.ca.gov.
CARB / California Emissions Compliance
This item may be restricted in California and other regions with emissions regulations. If applicable, it is intended for
competition/off-road use only unless otherwise stated. It is the customer’s responsibility to confirm local compliance before purchase.
Orders shipping to restricted areas may be canceled.
The sPOD Wiring Harness Adapter ties an ARB on-board air compressor into a sPOD switch panel and SOURCE power distribution system, so the compressor and the front and rear ARB Air Lockers can each be operated from their own sPOD switch. It replaces a section of the ARB loom rather than adding a piggyback circuit, and it is a universal accessory harness with no vehicle-specific application.
Key Features
- Adapts an ARB air compressor and air locker loom to sPOD switches and the sPOD SOURCE system
- Splits compressor, front locker and rear locker onto three separate switch positions
- Splices four circuits: compressor positive, ground, front locker and rear locker
- Universal fitment, not specific to any vehicle, engine or ARB compressor model
Installation Notes
The harness is not required on an ARB twin compressor when the compressor is not being used to operate lockers. For that setup, the single purple wire from the ARB harness attaches to any positive output on the sPOD SOURCE.
An ARB twin compressor cannot be powered through a sPOD. The compressor must be fed directly from the battery, with the sPOD handling switching only. Installation instructions are published by sPOD as revision 2.0 of the ARB Adapter Harness instruction sheet.
Product Details
- Brand: sPOD
- Manufacturer Part Number: 910111
- Also referenced as 300-ARB and 910110 in older catalogs and sPOD documentation
- UPC: 816482020968
- Application: Universal
- Sold As: Each
Shipping Height: 4.0
Shipping Length: 10.0
Shipping Width: 6.0